1、將機器搬到平穩的工作臺， 插好電源。[Move the machine to a stable workbench and plug it in. ]

2、將加熱好的煙油倒入儲油桶（不超過1500ml）。[Pour the heated oil into an oil storage tank (not more than 1500ml) ]

3、打開電源開關，點擊復位。[Turn on the power switch and click reset. ]

4、在注油器下方放個容器（裝盛注油器排出液體），切換至調試狀態，點擊準備； 完成后拿掉容器。 附 視頻（排氣， 清洗）（在硅膠管和注油器無空氣狀態下不需要進行進行此操作）。[Place a container under the oiler (to hold the liquid discharged from the oiler), switch to the debug state,  click Preparation, and then remove the container when finished. With video (Air exhaust, cleaning) (this  operation is not required when the silicone tube and oiler are free of air) ]

5、點擊序號（輸入相應需要注油的程序序號）， 點擊調出 （調出完成）， 點擊自動頁。[Click the archive page, click the serial number (input the corresponding sequence number of the program to be oiled), click the export (export completed), and click the auto page. ]

6、將放好產品的治具放在機器上， 切換至自動狀態， 點擊啟動進行自動注油工作。[Place the fixture with the product in place on the machine, switch to the automatic state, and click start to carry out the automatic oil filling. ]

7、完成后更換治具再進行啟動。[After completion, replace the fixture and start again. ]

8、完成生產任務后， 點擊復位， 再關閉電源開關。[After completing the production task, click reset, and then turn off the power switch. ]